Tag: Inspired

DIY: Cord Necklace

This week we have a DIY that is the perfect piece to complete your spring and summer wardrobe. Inspired by Marni’s incredible rope necklaces, we decided to put all of our cord to good use! This simpler design features one length of cord at a time, but you can always add additional segments to the necklace. We like wearing a clustered bunch to really make a statement, but you can also rock one at a time. These necklaces are a little bit nautical too, making them perfect for your summer vacation at sea!

DSC_0137

6mm Braided Metallic Cord

12mm Imported Chenille Twist

End Caps (small and large)

Lobster Clasp

Jewelry Wire

Jump Rings

Pliers

Scissors

E6000

 

Chenille Cord NecklaceDSC_01381. Measure your chenille cord around your neck, and cut depending on how long you want your necklace. Cut cord.

DSC_01422. Take your jewelry wire and hold the tip with the loop with a set of pliers. Create a knot by twisting the wire into a ball. This will allow the wire not to fall through the opening of the end cap.

DSC_01443. Place the loop tip into the end cap so it come out on the other side.

DSC_01514. Add glue and place cord into the end cap. Let dry and repeat on other side.

DSC_01595. Add a jump ring to each end and a lobster clasp to on end.

Braided Metallic Cord Necklace

DSC_01531. After cutting your cord to the desired length, take your smaller end caps and add glue inside.

DSC_01542. Place cord end into the cap and let dry. Repeat on the other side.

DSC_01603. Add a jump ring to each end and a lobster clasp to on end.

DSC_0167