DIY Harness by Taylor and Demolish


Harnesses have been a huge trend this season, so we were thrilled to see that one of our favorite DIY bloggers, Candy of Taylor and Demolish, made an awesome DIY body harness with supplies from our store. She combined some cool camo trim with a few round rings in order to make this edgy, trendy harness. Check out the tutorial below and stop by Taylor and Demolish to see more.



1.  Cut 2 pieces of trim at 7.5 inches each and 1 piece at 7 inches.

2.  Sew the 3 pieces of trim onto your smaller jump rings as depicted above.  The smaller trim (7 inches) is the one in the middle that is open on one end. You want to fold them about an inch over the the jump rings.

2.  With your extra trim, measure a piece that goes around your lower waist.  Cut this piece and sew one end onto one of the open jump rings.

3.  Sew a large jump ring onto the other end of the 7 inch trim.

4.  This is how it should look so far.  The longer trim will wrap around your waist and hook onto the small jump ring that is open.

5.  With the trim that is remaining, measure from where the large jump ring sits on your ribs, over your shoulder, diagonally across your back and down to the bottom of the harness, as depicted.  Add about 2 inches to this measurement and cut out two equal pieces of this length.

6. Sew both pieces onto the top of the large jump ring and then across the back to the bottom of the harness.

7.  You are almost done!  Remember the jump ring and trim that was left open in step 4?  Put on the harness and see how tight you want the waist to be.  Once you’ve figured it out, sew your snaps onto the inside of the trim and cut off any excess.

8.   Et voila!

3 thoughts on “DIY Harness by Taylor and Demolish

  1. Your style is unique compared to other folks I’ve read stuff from.
    Thanks for posting when you have the opportunity, Guess I’ll just bookmark this site.

Leave a Reply

Your email address will not be published. Required fields are marked *